If A car bumped the door and one section is dented.
Then Panel replacement.
If a matching section is available, one panel can be swapped without replacing the whole door. Garage Door Panel Replacement

Lifting cables on a door in Kent show their age as a few broken strands near the bottom bracket, long before they snap. We inspect them on every visit, replace both cables together with new bottom fixtures, and check the drums and bearings that wear alongside them so the door lifts evenly. The same crew covers Minniehill and Oxmead.
Same fees day or night · Kent
Pick the closest, or call (226) 909-6720
Repair & MaintenanceInspection, adjustment, sealing, and section-level repairs.
Springs & HardwareCounterbalance, track, roller, cable, and hinge work.
Openers & AccessOperators, safety sensors, controls, and access systems.
Installation & UpgradesResidential and commercial replacement, upgrades, sectional-door, and rolling-door work.The garage door on a house in Kent is usually the entrance the family uses most, so we treat a repair as something that has to hold. That means finding the cause rather than the symptom, replacing the worn neighbour as well as the broken part, and setting the door up so the opener is not straining.
Nearby Owen Sound, Chatsworth, Georgian Bluffs, Hanover, Meaford, West Grey, Brooke, Dornoch, Elmwood, Annan, Bognor, Kiowana Beach, Leith, Woodford, Big Bay, Keady and Kemble
Open, close, repeat, for years.
21 years in business · Book a visit: (226) 909-6720
Kent
Owners of older homes in Kent often need work on extension springs, wood doors and early openers, while newer homes tend to need torsion springs, belt-drive openers and insulated steel panels. We service both generations of door, and the pages below explain what applies to yours.

Garage Door Roller Replacement, Commercial Rolling Door Repair, New-Construction Garage Door Installation…
Tap a situation. The answer opens here.
If A car bumped the door and one section is dented.
Then Panel replacement.
If a matching section is available, one panel can be swapped without replacing the whole door. Garage Door Panel Replacement
If The bottom of the door is rusting through and flaking paint.
Then Bottom section replacement or new door.
Salt and moisture attack the lowest panel first; the rest of the door may still be sound.
If The wood door has gone soft along the bottom edge.
Then Door replacement.
Rot in a wood door spreads; we can help you choose a replacement that keeps the look you like.
GreyOntario
Every square is one home in a hundred.
Yes. The cylinder is removed and either rekeyed to a fresh combination, so any key held by a previous owner is retired, or replaced with a new cylinder carrying the correct tailpiece. New keys are cut and tested in the handle before the technician leaves. If a locked door has to be opened first, the technician confirms your connection to the property as a matter of course.
A lubricant made for garage doors, applied lightly to hinge knuckles, roller stems and the springs, following the door maker's own recommendation, since the right product and whether bearings are included varies by manufacturer. General-purpose penetrating oils are thin and wash away, and heavy grease attracts grit. Nothing goes on the track raceway or on a nylon or plastic wheel. The opener's chain or screw rail may take a lithium grease according to its manual, and the manual for your door names what its maker prefers.
Often, yes. The vertical track is meant to stand a fraction further from the jamb at the top than the bottom, so the closed door seals on its stop and swings clear as it rises. If a bracket has loosened or the track was set flat to the wood, the door drags along the stop moulding every trip. Resetting the spacing and taper, and tightening the brackets into sound wood, usually ends the rub.
Torsion springs mount on a shaft above the door and twist to store energy, lifting the door through cables and drums. Extension springs run alongside the horizontal tracks and stretch as the door closes, pulling it up through pulleys. Torsion systems tend to lift more evenly, take up less space beside the tracks and are the standard on most modern doors. Both are professional service items because of the energy they hold.
On-site assessment preferred · (226) 909-6720, open 24/7